国内精品久久久久精品

<pre id="9rp9n"></pre>
    <ruby id="9rp9n"><address id="9rp9n"></address></ruby>

                <ruby id="9rp9n"></ruby>

                 

                Ducati Monster handlebar M1 & M3 have been discontinued.

                This page is here for reference only.

                Holes for switchgear and throttle are pre-drilled for late
                model Monsters, approximately 2003 and newer.
                Earlier Monsters, some with aluminum bars,
                have different hole locations that we do not accommodate.

                The new M3 has an overall width is 29.5". Sweepback angle is 24 degrees.
                New hand position is in-line with the handlebar clamps.
                No other components need to be changed.

                Some models of Monster 900sie from late 1990's to 2002 have
                extra large instruments that do not clear the M1 bar.
                The instruments would have to be moved or changed. 

                Go to Handlebar Page
                Go to home page
                 


                M3 handlebar on 696 Monster

                 

                 FZ07side view

                 Yamaha FZ07

                 FZ07topview

                 A customer in Las Vegas has fitted an M1 handlebar to a Yamaha FZ07. Be advised, the switchgear holes are not in the correct location and the bar ends are not (Yamaha) threaded.
                They have a 1" deep, 0.720 counterebore.
                Check at an FZ07 forum for details.

                 

                 

                 

                 

                The M3 bar (pictured at top) is designed to provide clearance for bikes with the coffin
                type cast aluminum brake fluid reservoir.
                The center tube is longer and projects out
                over the tops of the forks.
                Most models built from 2003 thru
                2010 will use the M3.

                 
                                

                We no longer make the M3 or M1 handlebar.

                 


                 

                Pictured above is the original Monster bar which we
                 now call the M1. If your Monster has fork preload
                adjusters and plastic cups for brake and clutch fluid,
                then you need the original M1 handlebar. 

                 











                Go to Handlebar Page

                Go to home page

                 

                国内精品久久久久精品
                <pre id="9rp9n"></pre>
                  <ruby id="9rp9n"><address id="9rp9n"></address></ruby>

                              <ruby id="9rp9n"></ruby>